KF4 clone

[chia]

From mech to VV/VW the KF4 works decent... Currently on 28G 5/6 coils.. Works out like 1.2 ohms or so.. Next build may try dual..

 

[Jun Andaakabaa]

Has anyone owned a KayFun4 by Tobeco? heard lotsa good review comparing to other clones.

 

[chia]

Not sure where mine came from.. But it wicks not so good. Rewick and rewick, but keeps getting dry hits.
Many had resort to drilling for it to wick properly so beware.
The threading also not so good.
Personally I think the design is a tad complicated to clone properly. Only thing I like is the ease of refil.
Good luck in your quest

 

[Jun Andaakabaa]

Not sure where mine came from.. But it wicks not so good. Rewick and rewick, but keeps getting dry hits.
Many had resort to drilling for it to wick properly so beware.
The threading also not so good.
Personally I think the design is a tad complicated to clone properly. Only thing I like is the ease of refil.
Good luck in your quest

i heard before about the wicking issue on clones, hence i managed to find one that comes with an S-kit that provide addition air holes which solve the problem. Sounds like i found a good clone Thanks for responding Chia

Btw what build were you running on your KF4?

 

[dave51]

Has anyone owned a KayFun4 by Tobeco? heard lotsa good review comparing to other clones.

I have the Tobeco clone
I havent had any problems at all no leaks and airflow is great
My wicks just touch the deck and that the only thing you have to be sure of
If to long it gurgles if to short dry hits

Other than that the only leak i had was when i layed it on its side in a hot car
Ive run two different coils so far 1/6in micro and 5/64 micro both coils very close together both work great

 

[xxJollyRogerxx]

I am really liking my K4 clone. Not really sure who made it as it came from EBay and they didn't say who made it. The airflow is slightly better than the 3.1 IMO but not much. The "whistle" is gone though. I am really liking the top fill on it. That is primary reason I got it. I fought with the juice control a little bit until I worked it out ... err actually remembered which way was open and which was closed LOL I kept closing it and getting dry hits or I wouldn't open it all the way and it was wobbly.
The Lemo has a massive airflow though compared to this. But what I don't like about the Lemo and Lemo Drop is if it gets laid on its side it will leak juice out. Even having in my pocket and squatting down for a minute it will pour out. But the K4 will not. It hasn't leaked on me yet with the standard Kayfun build and wicking. I lay it on the side all the time.

 

[ahmadmfz]

For the lemo you've to get wicking right and make sure the silicon seal at the part you fill your tank is line up properly. Make sure connections are good. Never had a leak on mine.