KFL+ Fill Screw O Rings? Where to get?

[FAUXPUFF]

I've seen the replacement kits, but I was just looking for a link for the fill screw o rings for the KFL+ on their own. Many thanks!

 

[trouble1000]

Just use a tiny amount of PTFE tape on the screw threads. That's what I use on the Kayfuns I have that don't use the tiny O-rings. The tape will last for quite a few refills and fixes all the tiny leaks that I've had

 

[xpl0it]

You can find rubber o-rings at just about any local hardware store. If not, Home Depot and/or Lowes carries them.

 

[EuroChris]

Like the guy above said, check with your local hardware store.

 

[PONKAW]

Just a note:
I have found that the DANCO brand orings found at Lowes and HD will expand quite a bit if using citrus or cinnamon vapes.

If you can find the size you need in millimeters the seals at fasttech work quite well are very cheap and don't seem to "swell"

(Just an example...not the ones you should necessarily get)
https://www.fasttech.com/products/1411/10006430/1490203

 

[FAUXPUFF]

Thanks guys! Anyone have measurements on the o ring that I need?

 

[SmoKnoMoCigZ]

buy a roll of teflon tape in the plumbers section of ANY hardware store and wrap a tiny piece around the screw before inserting. it will cost a dollar or two and last you 2 lifetimes.

 

[crxess]

Pulled mine off the Plus. Might be stretched a touch, but retraced well when removed.

Approx. 1mm I.D. x 3mm O.D. x 1mm thick

Haven't located a source yet.

 

[TheKiwi]

Hey ho. I have a blog post on every oring you'll need for the kayfun. plus links. Hope that helps.


Burping out loud using Tapatalk