King v2 + Tobh

[jgod]

How can I get this atty to sit more flush on the mod?
I think this is the cause of the firing switch getting hot after a couple long pulls. my coil is .4

 

[Agamer]

1-Remove the atty from the mod
2-remove the top cap of the mod
3 unscrew the copper adjustment screw there should be two in there back out the big one
4-screw the atty all the way in
5-screw the copper screw in till it stops
6-adjust for battery rattle

also the switch should not be getting hot check again for shorts etc

Edit: what battery are you using to power that you are pulling 10.5 amps

 

[Miata GT]

The switch getting hot is due to resistence in the switch. You should take it apart and make sure everything is clean and shiney to reduce this. Sometimes it's just the switch. I had a Private v2 that I couldn't build below 0.5ohms before the switch would get how no matter what I did.

 

[jgod]

There is only one adjustment screw and when I take it off the mod doesn't fire nor does the atty screw in farther. Maybe its just my version of the tobh? I have the atty.'s adjustment pin all the way in.

i see this and wonder why mine isn't like that

 

[jgod]

The switch getting hot is due to resistence in the switch. You should take it apart and make sure everything is clean and shiney to reduce this. Sometimes it's just the switch. I had a Private v2 that I couldn't build below 0.5ohms before the switch would get how no matter what I did.

A tiny bit of corrosion on the threads, the coil is fine but maybe should be upgraded...
Still won't fix the problem with the tobh not sitting directly on top of the mod.

 

[jgod]

button does not get hot with nautilus which sits as it should on top