Knob for voltage adjustment

[V4ping20four7]

Does anyone know where to find some sort of knob to fit the adjustment screw on the potentiometer on the LM2596 so the voltage can be adjusted outside the modbox?
[h=3]http://www.google.com/url?sa=t&rct=...rt44JUnDOwdVrGXtg&sig2=4jopxdtMEcuGEZj4W7PE5Q[/h]

 

[BJ43]

http://www.e-cigarette-forum.com/forum/battery-mods/237203-pot-knobs.html

 

[V4ping20four7]

http://www.e-cigarette-forum.com/forum/battery-mods/237203-pot-knobs.html

Umm yes pot knobs, if that is the correct term for it, I don't know, is why I am asking.

 

[asdaq]

That is a link to just what you are asking about. The pot screw is 2mm in diameter and quite short, if you wanted to go micro you could use a presta valve nut, the part that you loosen to let the air out. In the upper left corner of this pic:

It's threaded for M2, has a slot in the bottom to hold glue or solder has an OD of 4mm and is knurled for two-finger control. I'm looking to work it into a mod soon.

 

[V4ping20four7]

That is a link to just what you are asking about. The pot screw is 2mm in diameter and quite short, if you wanted to go micro you could use a presta valve nut, the part that you loosen to let the air out. In the upper left corner of this pic:

It's threaded for M2, has a slot in the bottom to hold glue or solder has an OD of 4mm and is knurled for two-finger control. I'm looking to work it into a mod soon.

Ahhh, I'm an idiot, lol thanks!

 

[asdaq]

Correction, the pot screw is 2.5mm in diameter, which makes a fair amount of difference.

And a pot knob could look like this:

Also, thanks for the motivation to finally do this.