Lambo 4.0 replacement part

[dirtydog2008]

Don't know where to post stripped lambo top cap WHERE CAN I GET A NEW TOP CAP AT?? THANKS

 

[dirtydog2008]

this is what i need the cap that screws onto the lambo 4.0

 

[Jeremy Evans]

that sucks, was it easily stripped? I was thinking about getting this one in a week or so. Do you like it ? Do you have another APV to compare it too?

 

[DrMA]

OP, sorry I don't know of anybody selling that top cap separately. Perhaps JB Weld would work?

that sucks, was it easily stripped? I was thinking about getting this one in a week or so. Do you like it ? Do you have another APV to compare it too?

The Lambo V4 is a nice intro to VV vaping. I find it works best with attys in the range of 1.8-2.2 Ohms. These lavatubes tend to be rated 2.5A/10W max, but they can rarely deliver that kind of power. I've measured mine pushing a max of 1.75A with a 2.2O atty, at any voltage setting above 4V. I'm a high-power vaper, and the Lambo simply can't give me, the 12-14W I'm looking for.

 

[Jeremy Evans]

OP, sorry I don't know of anybody selling that top cap separately. Perhaps JB Weld would work?



The Lambo V4 is a nice intro to VV vaping. I find it works best with attys in the range of 1.8-2.2 Ohms. These lavatubes tend to be rated 2.5A/10W max, but they can rarely deliver that kind of power. I've measured mine pushing a max of 1.75A with a 2.2O atty, at any voltage setting above 4V. I'm a high-power vaper, and the Lambo simply can't give me, the 12-14W I'm looking for.

Thanks for the advice I dont think that I would like that very much then since I tend to use 2.5-3.5 ohm heads when I rebuild them.

 

[dirtydog2008]

it can deliver the 12-15 watts of power you have to use rebuildables i had it pushing 13.3 watts had a did clone on it at 1.2 ohms at 4.0 volts

 

[the_maiden_fair]

I was just searching for the same thing, dirtydog. I fully screw on atomizer, and it only hits at best once out of 3 button pushes. I thought maybe the top cap was not correctly working. I have taken it off and completely cleaned it, still with no luck. if I find anything about just parts, I will post. If you find anything before me, please let me know!

 

[the_maiden_fair]

I found this http://www.e-cigarette-forum.com/forum/lavatube/379010-stripped-threads-lavatube-totally-wicked-clone.html. It may help my problem, not sure if it will help yours.