Lancia Clone

[EdwardOrn26]

I picked up 2 Lancia clones. 1 is an Ivogo and the other is an Cig Cloud. Both have one problem. The airflow plugs sit very loose in the air holes. There so loose that when you take a hit they pop out of the holes. On the first one I got from a Chinese vender I put strands of cotton around the plugs and jammed them in so they were tight in the holes. On the second I got from a USA vender I used a 1/4 inch peace of #32 kanthal and jammed it in that way. Both methods were a total pain in the ..... The thing is once I got these working right they both put out an incredible vape. There so good I don't want to return them. The Chinese vender wants me to do a video and ill have to pay postage to return it. Since I only payed 15.00 for it I'll keep it in its current configuration and not change the plugs. The other ill communicate with the vender as there a really good site. Any one have a problem with this atty.

 

[VenusianSky]

I've got an iVogo and the plugs go in pretty tight for me. Actually, it was so tight, that I was getting a bit of leaking on a sealed plug until I realized it wasn't pushed in as far as it could go. Using the tip of my pliers, I pushed down on it as hard as I could.

I am impressed about the quality of my iVogo. The machining seems to be quality. It was very clean, though I cleaned it myself and packaging was nice. I would like to see a comparison between it and a authentic.

The vape quality is really good for a device that looks like may be just a gimmick. Biggest con for me is juice capacity. I've been filling it past the deck, to near the top of the plugs. The plugs consume so much area, it doesn't leave enough room for the wick. They should have made the sealed plugs nearly flat to the deck. I have to use pliers to take mine out anyways. Also, I replaced the O-rings with some thicker ones that work much much better. I can use the glass sleeve and it doesn't pull off if I grab it. They were spare O-rings from my Orchid.
For me, it falls short on flavor next to my Magma, but with a gain of vapor production because of the air flow options. However, I really like the look of this atty.