Let the fun begin

[The Kid]

bought me a RSST. i have been building mico's for my Pro tanks for over 2 months and i thought it was time for me to move up. mico of 12 wraps of 28 gauge gave me 1.9 cotton wick. (I WILL NOT DO SS ) i have it set up as a auto wick and its doing fine but i have to go to my shop today so i can drill out the air hole to a 3/32.

 

[The Kid]

https://www.dropbox.com/s/j1ike3iqqulkkyb/IMG_20140111_115342.jpg
https://www.dropbox.com/s/atujcayokaaihqv/IMG_20140111_115633.jpg

 

[Exile]

Im sure it takes a while for that coil to heat up. Take a few coils off of it, get it to around 1.2-1.4 ohms and it will heat up a lot quicker, and hit a bit harder...

 

[The Kid]

did a change up, got to 1.4 and went side ways. she is chunking vapor and flavor now. thank you Exile for the tip.

 

[VaPreis]

(I WILL NOT DO SS )

Even if I say "Please"?

 

[The Kid]

Even if I say "Please"?

No no no lol

 

[bender817]

No no no lol

But you could still make a 1/8" mini coil, about 6-7 wraps, and just torch it, roll it up, and drop it in... It cant hotspot on a mini or micro coil. lol

For real though, the ss cable wicks so fast its unreal, but I don't like ekowool so I put a little mesh around it and its a beast.

 

[The Kid]

going to make a dual coil for it now

 

[bender817]

going to make a dual coil for it now

Check this out. We've been doing some idiotic stuff. You should double post it over here as well when you get it done. http://www.e-cigarette-forum.com/forum/rebuildable-atomizer-systems/510584-rsst-dual-coil.html