hi everyone i am using berserker v1.5 and i have a problem like that; when i puff about 10-15 times liquid come through the driptip how can i stop that and where is the problem?
liquid come through to driptip
- Thread starter fireinthehole15
- Start date
- th_trl_thread_readers 0
- Status
Usually spit back is caused by under wicking, so try stuffing a bit more cotton in the coil - has it only started happening after a rewick?
Hello @fireinthehole15, that sounds like a wicking issue. Too short, too thin or a combination of both.
thanks for your attention maybe cotton is a little thin i will add more cotton and i will write back
@fireinthehole15
Agree 100% a little bit more cotton inside the coil should fix the overfeeding issue.
It could also be that you’re not reaching the right heat flux. Maybe watts are too low, but it usually depends on the cotton amount!
Eventually try to use a cotton which tends to saturate easily not allowing to many juice to come in, like Angorabbit for example.
Agree 100% a little bit more cotton inside the coil should fix the overfeeding issue.
It could also be that you’re not reaching the right heat flux. Maybe watts are too low, but it usually depends on the cotton amount!
Eventually try to use a cotton which tends to saturate easily not allowing to many juice to come in, like Angorabbit for example.
- Status
Similar threads
