Looking for a coiler

Status
Not open for further replies.

Lova

Super Member
ECF Veteran
Nov 5, 2014
367
245
Finland
I bought custom made ones made from industrial strenght aluminium, got 1.6mm and 2.5mm for 10€+postal service,essentially they are kuro coilers, but custom made and from way heftier aluminium :D But I don't get what is up with 'only way to get coils you don't have to pinch together is using a gizmo thingy coil jig thing' I personally can do perfect dual parallels with my coilers in seconds without any overlapping or any pinching required o_O
 
Last edited:

jchisholm

Senior Member
ECF Veteran
Oct 19, 2014
136
140
Nova Scotia
thats real off :blink: I use 20-28gauge and I am succesful in winding the coils each time. although I use a kuro coiler clone, it might not be the exact same as the coil master one, but it shouldnt really be that hard. Even when i press down hard it still winds up a perfect coil. The only slight problem i experience is what you mentioned though, with the wire winding over itself, but that only happens to me when I use single strange 28 gauge (very thin), could be possible that it is because you use higher gauge wires as well?

Nope never use anything higher than 28AWG. I note that Coil Master is acknowledging there are issues with the screws supplied on the original Coil Master
(but their commercial e-site is currently buggy too and will not accept my credit cards for the upgrade screws!)
 

CMD-Ky

Highly Esteemed Member
ECF Veteran
Verified Member
Sep 15, 2013
5,321
42,395
KY
RBA Supplies corrected the CoilMaster problem with a different set screws, I have not experienced any problem with mine 32 to 28 gauge.

Nope never use anything higher than 28AWG. I note that Coil Master is acknowledging there are issues with the screws supplied on the original Coil Master
(but their commercial e-site is currently buggy too and will not accept my credit cards for the upgrade screws!)
 
Status
Not open for further replies.

Users who are viewing this thread