RDA looking for a new rda

Status
Not open for further replies.

Wolfenstark

Vaping Master
ECF Veteran
Verified Member
Sep 1, 2014
4,815
14,724
Perth , Australia
I got a plume veil tobeco clone on Friday and it has been great.
It is my first RDA. Have a RTA.
So far I have only done single builds.
Only recently started building on the RTA a Kayful light plus - So with this RDA to be going good for me after a couple of days I have to say its a good one.

With this one don't know if its common to all or just because its new but I do find getting the build deck out takes some force and you set the air holes up for single coils or dual coils - as far as I know.

The base has holes that you line up with holes going to the negative posts when you put the bottom back onto the deck and it also has slots for air holes where you slide it on to have one open for single builds or slide it on a different way to have both slots open for dual builds.

Two slots are parallel to each other for dual builds the other has one slot and no slot parallel.

Its probably easier to see than me trying to explain.
 
Last edited:

Paradicio

Super Member
ECF Veteran
Verified Member
May 30, 2014
445
386
Altadena, CA
I've got a couple of Tugboat V2's and one Tugboat V1. I've also got 2 Plumes. I will say without a doubt the Tugboat V2 is the better atomizer. Deeper well = more juice = less dripping. A smother hit, and wide open its quite the cloud producer. Close off the airflow a bit and you've got a nice flavor chaser.

All of that said, my current favorite RDA is the Mutation X V2. I love the deep well (thought not as deep as the Tugboat), 4 post design for super easy building, a NICE drip tip included, and it'll chuck clouds or deliver great flavor depending how you adjust the airflow. And, to top it all off, it's only $30 for an authentic atty. Can't go wrong!
 

JD1

Vaping Master
ECF Veteran
Nov 20, 2010
4,180
2,644
KY
I've got the 1:1 Veritas clone from FT and it's about all I'm using since it came in over a week ago. Great flavor and vapor at 1.3 ohms on a mech, holds a ton of juice, and very leak resistant.

Sort of depends on what you're looking for though. It's not as good for low sub ohms or cloud chasing as some other choices. I've also read some reviews that claim the veritas runs a little cooler than the magma or tugboat. I like that, but some don't.
 
Status
Not open for further replies.

Users who are viewing this thread