Hi, Im new to ECF but not new to forums. I have been vaping for about 4 months. Enjoying rebuilding the most. Is there a section i am over looking that shows and describes different setups and rebuildable dripping setups?? I have my way of doing it but I am curious of some other folks normal setups and how it works for them. TIA!!
Looking for RBA wick setups.
- Thread starter KBizzle
- Start date
- th_trl_thread_readers 0
- Status
Well, im using an AGI atm in dripping mode. I have a nimbus coming soon and 2 chimbus coming by early next week. I like all the space in these 20mm drippers but i have run across a few pictures of some pretty knotted up setups. I was kinda hoping to learn those. Then again, they may have been using cotton and it just looked that way.
I've been enjoying a .7 ohm coil of 28 AWG A1 Kanthal around silica wick but, lately I've been trying out 1.5 ohm Micro coils, 12 wraps of 30 AWG A1 around a needle dropper for the jig and using a cotton wick.
I like the cotton 8-9 wrap with 28 gauge kanthal coming in at about 1.5 ohms myself, clean tasting and hits hard.
just twist a long thread out bring the center together and the ends let it twine itself up and repeat untill you have the wick your looking for takes like a minute to make one thats 30 mm in my case
I'm using the aga t2, and i wondered would it work to roll a strand of cotton up in the ss mesh to help with wicking. i tried the cotton alone and it burned to easily, i thought maby the ss would help protect it from the coils. as you can tell I'm new at this. i was just wondering.
have a great vape y'all
have a great vape y'all
Last edited:
- Status
Similar threads
