Loose cartridges?

[Oklahoma]

How many times have you took a vape hit and the cartridge came off in your mouth? I know they seem to loosen up from the constant remove to reload with juice over and over.

A new cartridge fits tight. Wish there was a way to modify the cartridge to fit tighter longer.

 

[Cuando]

Do a forum search for 'loose cartridges', there's a great method developed by Sun. Terraphon actually did a video showing how to do it, as well.

 

[Oklahoma]

Yes, the method below helped.

Hi ALL,

For those of you guys, or gals that have had your cartridge slip out easily, I have found a quick fix.

The problem is that the atomizer is a little too wide and the cartridge is just a little bit too small. Also, liquid seeps into the two while you inhale which makes it slippery and easy to come off.


What you need:

1 lighter

1 Sewing Needle

All you have to do is heat up the tip of the needle until it is red hot and quickly melt (a little) onto the part of the cart that connects to the atomizer.

I do it vertically on 4 sides. Try your best to make it evenly spaced but it doesn't matter too much. The point is to make 4 ridges. After you do that, the cart should snap in pretty tight and fit very snug.

I hope this helps because I have had the cart fly off on me many times, luckily on my carpet or else it would have been pretty bad.

Good Luck and I hope this info helps my fellow e-ciggers

~Belowme

 

[GermanGoodness]

Y

I hope this helps because I have had the cart fly off on me many times, luckily on my carpet or else it would have been pretty bad.

LOL Oklahoma! How hard ARE you sucking?!

I've had leaky carts/atomizers, but have never had a cart fly off.

 

[GrimmGreen]

Yes, the method below helped.

Hi ALL,

For those of you guys, or gals that have had your cartridge slip out easily, I have found a quick fix.

The problem is that the atomizer is a little too wide and the cartridge is just a little bit too small. Also, liquid seeps into the two while you inhale which makes it slippery and easy to come off.


What you need:

1 lighter

1 Sewing Needle

All you have to do is heat up the tip of the needle until it is red hot and quickly melt (a little) onto the part of the cart that connects to the atomizer.

I do it vertically on 4 sides. Try your best to make it evenly spaced but it doesn't matter too much. The point is to make 4 ridges. After you do that, the cart should snap in pretty tight and fit very snug.

I hope this helps because I have had the cart fly off on me many times, luckily on my carpet or else it would have been pretty bad.

Good Luck and I hope this info helps my fellow e-ciggers

~Belowme

now that's a good idea , this should help with the slightly loose fitting Dura carts

 

[BBuzzard]

Never once have had this happen and I have 3 different models.

 

[Chris From Cali]

I had my carts get loose but none fly off. I don't think I use them long enough for that

 

[Oklahoma]

Maybe a better explanation is warranted here.

when I take a hit and go to remove the e-cig the cartridge sticks to my lips.

 

[ironsheik]

what i did was just get a lighter and use the heat to slightly soften part of the cart that goes in the atomizer and bend it outwards but not too much... Thats it..... no more loose cart....