Hi. I've got a few Vivi nova tanks and one of them has a loose positive pin. I can move it sideways about 2mm and with the atty head on it sticks out around 2mm from the base.
The problem with this is that when I screw it on to my battery, it pushed the coil and wick out of place and let too much liquid in. I fired it and it popped a shot of boiling liquid up the drip tip and into my mouth
I'm thinking of getting my dremmel and grinding down the bottom of the pin so it's a bit more flush, or does anyone have a better solution. I only use this one for work so I'm not too bothered if it's knacked as it's a cheap tank.
Any input would be greatly appreciated
Sent by Internet carrier pigeon
The problem with this is that when I screw it on to my battery, it pushed the coil and wick out of place and let too much liquid in. I fired it and it popped a shot of boiling liquid up the drip tip and into my mouth
I'm thinking of getting my dremmel and grinding down the bottom of the pin so it's a bit more flush, or does anyone have a better solution. I only use this one for work so I'm not too bothered if it's knacked as it's a cheap tank.
Any input would be greatly appreciated
Sent by Internet carrier pigeon
