Low air coils suggestions?

[juggalofisher88]

Hey all got a problem at the moment have a igo-w with the air holes drilled out to 1/16.
I have a .5ohm dual coil triple twisted 30g set up.
No where near enough air way to hot and I have no way to drill em out till I go to inlaws in a few days.
I only have 30g A1kanthal at the moment also.

So. Need something with good flav/cloud around .7ohm seems to be sweet spot for the airflow I have. So before I go build a coil or 2 or 4....
Any suggestions

Also should I go 5/64 3/32 or even 1/8 when I drill my air holes out

Powered by Area Rom Centura 1.3

 

[propofokgov]

I would keep with what you got, just add wraps to your coils. If you have 6 wraps, do 8 or 9

 

[juggalofisher88]

I have 10wraps 2mm id not much room for my clumsy hands to work with look

Powered by Area Rom Centura 1.3

 

[SLIPPY_EEL]

I would step up gradually with the air instead of jumping straight to the 1/8, I have a cap on atm that has 2x 1/8 hole's but i'm vaping at .2Ω with I widebore DT, I have another cap with 2x 3/32 for builds about .5Ω.. yeah start with 2x 2mm's is good for .5 upwards imo.

if you have a bit of time on your hands you could try the braided wire like in my sig below or nano's hit hard if you wick them properly

 

[juggalofisher88]

Yeah I had simple 3 braid at .7ohm it was GREAT

I like a nice airy draw, but I'll do the step up to 3/32 and if I need more air I got another cap that I'll drill out 4 1/16 holes (or at least try lol

Powered by Area Rom Centura 1.3