Madvapes box mod kit

[bfitz]

Hello everyone,

Just wondering if anyone has put this kit together and if they had any problems with it. I have basic soldering skills and have put together small electronic project kits before, just want to know what I am getting into before I start.

Thanks everyone

510 Box Mod Kit

 

[horton]

I put one together quite a while back and it was very easy to do. You said you have basic soldering skills, and that's all you need. I believe there even is a how-to on their site. The worst part was soldering the pos lead to the 510 connector. I found that by roughing it up a little with a small file and using a some extra liquid flux it made it much easier. They may have added the 510 conn already pre-soldered, but I could not tell from the picture. Thought I read that somewhere.
You will find it to be an enjoyable project. Good luck.....

 

[been there]

I built a couple of those and like Horton said if you have basic soldering skills no problem and its good starter project .

 

[cskent]

I've put a few of those together in the past. I don't like lights on my stuff so I just leave out the resistor and LED and fill in the hole that's been drilled for it with epoxy. That also makes it quicker and easier to put together. I think it takes less than 1/2 an hour to finish building one.

 

[Mike36609]

I built one well over a year ago, my first mod. Still works as good as new, though I rarely use it anymore. I did use it every day for three to four months as I was learning the ins/outs of the vape world.

Good kit for somebody new to vaping, very functional, easy to build, should be easy to repair, though I never had too, and it's a good first bigger battery for those at the beginning of the learning curve. Makes a good backup as well, if something ever happens to your primary PV.

 

[oplholik]

Might be a good idea to have a few of those around considering what the FDA might do. Instructions are in MV's knowledge base. I've never done this, but think I'll pick up a few of these.