Major issue with Njoy Npro and Dripping

[ARPunk]

Hi all,

When I first got my NPro, it worked fine. I would drip and there would be no issues. When one of my batteries died, I had them send me a new one, and I also ordered 6 or so extras.

The issue that I am having is this:

I will put two drops on the mesh of the atomizer and take a drag. Sometimes, the LED will stay lit after I take a drag, and the atomizer will get RED hot, sizzle, and then the LED will flash 10 times. I can then no longer take a drag unless i either unscrew the battery or blow into the cartridge.

Has anyone experienced this? I'm burning through atomizers fairly quickly - even the PeeWee atomizers from PureSmoker are doing the same with the NPro batts.

 

[DaveB]

I drip with my Npro and up to now i have not had a problem.
What kind of juice have you been using? Also, you do not have to drip on the mesh. Try angling the drip towards the sides of the atomizer.

 

[Sun Vaporer]

Hi all,

When I first got my NPro, it worked fine. I would drip and there would be no issues. When one of my batteries died, I had them send me a new one, and I also ordered 6 or so extras.

The issue that I am having is this:

I will put two drops on the mesh of the atomizer and take a drag. Sometimes, the LED will stay lit after I take a drag, and the atomizer will get RED hot, sizzle, and then the LED will flash 10 times. I can then no longer take a drag unless i either unscrew the battery or blow into the cartridge.

Has anyone experienced this? I'm burning through atomizers fairly quickly - even the PeeWee atomizers from PureSmoker are doing the same with the NPro batts.

ARP--Because you drip, the e-liquid drips down into the battery from the atomizer and gets into the housing of the pressue switch causing it to stick on--Blow and suck on the battery hole and also wack the battery down thread end onto a table hard all in an effort to clear the sticky switch---This will continue to happen until you give up dripping--that is the only way to stop ruining your equitment---Sun

 

[f7eleven]

one of my NPro batteries is doing the same thing -- but surprisingly, the draw is also now much nicer/lighter. I've just been dripping less at a time to avoid the sticking. and if it does stick (usually first drag after a drip) then I unscrew the atomizer as quick as possible