Freemax Maxus 200W Kit With M Pro 2 Tank
I received this for review from Tina @ Freemax… Thank you Tina
Maxus ProTank Resin Edition:
I love the feel and the look of this tank on top… the Diamond beveled glass is so pretty in the sun… mine has a tint of pink in it, but that’s either from my cotton candy juice or the orange O-rings. There is matching colored resin on both the top & bottom of the tank and a matching 810 drip tip makes it look so classy!….… The coils are great with the little shelf to keep you from running dry Part of the M Pro 2 series…The kit comes with 2 coils, .15 & .20 ohm. The .20 ohm comes pre installed so that’s the one I am still using 2 weeks later...
Maxus 200 W Mod:
The battery door is the side with the design on it, no rattle with 2 strong magnets..… mine is the blue and I love it… it’s the resin swirls that make it look so classy….and also helps to keep it from sliding out of your hand…..I love the Type C charging port… I rarely use them but that’s the one I use for my phone so there is always one around….It supports single batter load… so when you are swapping out batteries it comes on as soon as you get 1 inserted(80w)...It also says no polarity… so it doesn’t matter how you put them in.. but I usually do it the same way I do all my other dual 18650’s, although I did try it to see how it works and any way you put the batteries in it works & reads 200w.......
Easy to use menu, 3 clicks and it brings up all the functions. There is VPC, Bypass, TC,TI, SS, NI.4 TC memory.
You can set your Timeout, test coil, puff counter, time used, C/F & reset...
You can check the power in each battery, the version & temp.
The OLED screen shows everything you need(not colored)
Pros:
Lots of protection, Single battery, Any battery configuration, comfortable fit, Classy looking matchy matchy, the 5 ml tank last me almost all day….
Cons:
I wish the filling hole was just a little bigger… I had an air bubble back out a lot of juice on more than one occasion…..
Parameters
Tank Capacity: 5ml//2ml (TPD)
Battery: 18650*2
Charger Specification: 5V/2A
Resistance Range: 0.1-3ohm
Input Voltage: 3.3-4.2V (Single battery) / 6.6-8.4V (Dual battery)
Output Voltage: 0.7-8.4V
Output Wattage: 5-200W/100-315℃/200-600℉
Output Mode: Power/VPC/Bypass/TC-TI/TC-SS/TC-NI/TCR
In The Box
1*Freemax Maxus 200W VW Mod
1*Freemax MPro 2 Tank Resin Edition (Freemax 904L M2 Mesh Coil 0.2ohm)
1*Extra Freemax 904L M1 Mesh Coil 0.15ohm
1*Extra Glass Tube 5ml (Individual packaging of extra glass for TPD edition)
1*Extra O-ring
1*Type-C USB Cable
1*Warning Card
1*Warranty Card
1*User Manual
I received this for review from Tina @ Freemax… Thank you Tina
Maxus ProTank Resin Edition:
I love the feel and the look of this tank on top… the Diamond beveled glass is so pretty in the sun… mine has a tint of pink in it, but that’s either from my cotton candy juice or the orange O-rings. There is matching colored resin on both the top & bottom of the tank and a matching 810 drip tip makes it look so classy!….… The coils are great with the little shelf to keep you from running dry Part of the M Pro 2 series…The kit comes with 2 coils, .15 & .20 ohm. The .20 ohm comes pre installed so that’s the one I am still using 2 weeks later...
Maxus 200 W Mod:
The battery door is the side with the design on it, no rattle with 2 strong magnets..… mine is the blue and I love it… it’s the resin swirls that make it look so classy….and also helps to keep it from sliding out of your hand…..I love the Type C charging port… I rarely use them but that’s the one I use for my phone so there is always one around….It supports single batter load… so when you are swapping out batteries it comes on as soon as you get 1 inserted(80w)...It also says no polarity… so it doesn’t matter how you put them in.. but I usually do it the same way I do all my other dual 18650’s, although I did try it to see how it works and any way you put the batteries in it works & reads 200w.......
Easy to use menu, 3 clicks and it brings up all the functions. There is VPC, Bypass, TC,TI, SS, NI.4 TC memory.
You can set your Timeout, test coil, puff counter, time used, C/F & reset...
You can check the power in each battery, the version & temp.
The OLED screen shows everything you need(not colored)
Pros:
Lots of protection, Single battery, Any battery configuration, comfortable fit, Classy looking matchy matchy, the 5 ml tank last me almost all day….
Cons:
I wish the filling hole was just a little bigger… I had an air bubble back out a lot of juice on more than one occasion…..
Parameters
Tank Capacity: 5ml//2ml (TPD)
Battery: 18650*2
Charger Specification: 5V/2A
Resistance Range: 0.1-3ohm
Input Voltage: 3.3-4.2V (Single battery) / 6.6-8.4V (Dual battery)
Output Voltage: 0.7-8.4V
Output Wattage: 5-200W/100-315℃/200-600℉
Output Mode: Power/VPC/Bypass/TC-TI/TC-SS/TC-NI/TCR
In The Box
1*Freemax Maxus 200W VW Mod
1*Freemax MPro 2 Tank Resin Edition (Freemax 904L M2 Mesh Coil 0.2ohm)
1*Extra Freemax 904L M1 Mesh Coil 0.15ohm
1*Extra Glass Tube 5ml (Individual packaging of extra glass for TPD edition)
1*Extra O-ring
1*Type-C USB Cable
1*Warning Card
1*Warranty Card
1*User Manual
