Initial Impressions...
01. Would have preferred the tube have been milled as a single piece without a top cap.
02. Finish is very, very good. But not perfect: Interior vent holes required slight deburring.
03. No battery rattle (HB2/HB4/HB6/HG2) so long as the positive protrudes ~1mm past the top cap.
04. 2JNT silver negative contact and stock spring pictured. Magnets result in a noticeably softer activation.
05. Delivered caked in debris as per typical MCV fashion. Electrochemically cleaned all contacts before use.
06. As with my past experiences with 2JNT, the negative contact was delivered in pristine condition.
07. Field replaceable O-ring insulator vs POM at the negative. Large pitch threads top and bottom.
08. Will verify top cap diameter and pitch measurements within a few days (for hybrid atomizers).
09. Locking ring is not child-proof, nor will it prevent accidental firing within a pocket.
10. Locking ring is fluid and requires only a flick of the finger to engage/disengage.
11. Would have preferred that the top cap were milled to double as a juice well.
01. Would have preferred the tube have been milled as a single piece without a top cap.
02. Finish is very, very good. But not perfect: Interior vent holes required slight deburring.
03. No battery rattle (HB2/HB4/HB6/HG2) so long as the positive protrudes ~1mm past the top cap.
04. 2JNT silver negative contact and stock spring pictured. Magnets result in a noticeably softer activation.
05. Delivered caked in debris as per typical MCV fashion. Electrochemically cleaned all contacts before use.
06. As with my past experiences with 2JNT, the negative contact was delivered in pristine condition.
07. Field replaceable O-ring insulator vs POM at the negative. Large pitch threads top and bottom.
08. Will verify top cap diameter and pitch measurements within a few days (for hybrid atomizers).
09. Locking ring is not child-proof, nor will it prevent accidental firing within a pocket.
10. Locking ring is fluid and requires only a flick of the finger to engage/disengage.
11. Would have preferred that the top cap were milled to double as a juice well.
Last edited:
