I am trying to build a tin mod and can not find the nuts to fit the threads on the ego adapters. I was told that you have to buy a tap and make your own or to use a lot of JB weld or epoxy to attach the adapter to the tin. I have used epoxy and other like products to do mods but I find that it make them very heavy. What I was wondering is the add on Ebay said they were manufactured and not homemade. If there are M7 X 0.5 Mertic nuts out there where can you find them I have searched all over the internet, went to every hardware nut and bolt shop, I even raided my dads nuts and bolts buckets last time I was at his house. My dad has about 6 or 7, 5 gallon buckets filled with nuts and bolts and they weigh a ton lol. But could not find anything that would work. Has anyone here found these nuts or be willing to sell some of them. The guy on ebay is asking 25 bucks for 10 of them and I only need a couple to do my mod.
Mertic M7 X o.5 nuts seen on Ebay, This is a question for the moders.
- Thread starter Frosttosha
- Start date
- th_trl_thread_readers 0
- Status
I have tried the type you press in but the tin on the mod in building does not hold it very well. I did find this web site:
MAHR FEDERAL Model# ENT-1116, NUT, HEX, M7X0.5, .375 A.F, .060 THK, SST, EAS-2887, EDI
They have a M7 X 0.5 Hex nut for sale also but it is over 5 dollars. That ebay listing is starting to look better and better. You have to buy 10 of them for 25 dollars but that is just 2.50 a piece but it is still so much for a M7 X 0.5 nut. But I can not find them anywhere else but these 2 places.
MAHR FEDERAL Model# ENT-1116, NUT, HEX, M7X0.5, .375 A.F, .060 THK, SST, EAS-2887, EDI
They have a M7 X 0.5 Hex nut for sale also but it is over 5 dollars. That ebay listing is starting to look better and better. You have to buy 10 of them for 25 dollars but that is just 2.50 a piece but it is still so much for a M7 X 0.5 nut. But I can not find them anywhere else but these 2 places.
- Status
Similar threads
- Locked
