Ok I've searched high and low for anything related to my problem and could not find anything so here it goes.... I recently purchased the glorious "mini Buddha " rda and upon un boxing this religious symbolic rda I cleaned it up real good go and throw a standard 6 wrap 24g test build in it. Once my coils are nice and centered, I go and test fire it and ....... Nothing the 521 tab won't read my rda. So I throw it on the rx200s and boom fires up I pinch and get the hot spots out and I notice the resistance is all over the map from .30 to .27 .48. No matter what build I put in this thing I can never get a good solid steady resistance any incite would be appreciated as I've never had this issue with any of my other rdas in my collection.
Mini Buddha rda wtf
- Thread starter DevilsVirus
- Start date
- th_trl_thread_readers 0
- Status
Bad positive post insulator, positive post is not set tightly, positive 510 adjustment pin (bottom of the rda) is wiggling and needs tightening up. If it is still not reading right after that, take the whole positive assembly apart, inspect for any burrs up through there, they could be causing a dead short. If it isn't that, get a replacement or refund and send the RDA back for an RMA, it is defective.
Thank you for this info I'm going to contact the vender right away guess that's what I get for buying .... online lol
- Status
Similar threads
