Mini Precision Screwdriver, Tube Mod?

Status
Not open for further replies.

jimbalny

Ultra Member
ECF Veteran
Verified Member
Apr 3, 2011
1,004
435
New York
Hey ladies and gents, i was wondering if you guys could give me some input on this mini screwdriver i found at walgreens for 2.50usd in comparison to my ego and tell me if there are any batteries that would fit this case. Looks like it could make a nice little mod...

The inside it hollow and the top screws off.

Sent from my PC36100 using Tapatalk
 

Attachments

  • uploadfromtaptalk1306508831894.jpg
    uploadfromtaptalk1306508831894.jpg
    21.7 KB · Views: 163
  • uploadfromtaptalk1306508918983.jpg
    uploadfromtaptalk1306508918983.jpg
    21.1 KB · Views: 131

jimbalny

Ultra Member
ECF Veteran
Verified Member
Apr 3, 2011
1,004
435
New York
The inside diameter is 3/16", depth of tube is about 3 1/2 " before it starts to taper down at the pen end. The threads for the cap look almost identical in size to the outter ego battery threads. Tested by screwing a cone over it, the threads are just a bit more rough but it goes over. Looking at it, I can probably even drill a hole for an ego connector and use that for the switch, or eeven use the pen clip as some kind of mechanical switch.

This would make a really nice piece for work as my company shirts have a front pocket.

Sent from my PC36100 using Tapatalk
 
Status
Not open for further replies.

Users who are viewing this thread