The absolute BEST way to clear any unwanted e-juice from the switch (activation button) is to spray "Ignition Wire Drier" into the switch. Works even better than WD40. This not only displaces moisture but it also leaves a barrier that repels future moisture. Just spray and then wipe the excess overspray from around the switch with a paper towel. Start vaping again immediately! There is a nine page discussion titled "Wet box" but I'm unable to post a reply there as I am new to this forum.
For those that may not know... Ignition wire drier is an aerosol spray used for displacing water from an automotive ignition system. Specifically plug wires, distributor cap & rotor contacts & (on older cars) ignition contact points. So check with your local auto parts store or do an online search. You may want to search with both possible spellings as Prestone spells it Wire Drier whereas Permatex & Gunk have it spelled Wire Dryer.
For those that may not know... Ignition wire drier is an aerosol spray used for displacing water from an automotive ignition system. Specifically plug wires, distributor cap & rotor contacts & (on older cars) ignition contact points. So check with your local auto parts store or do an online search. You may want to search with both possible spellings as Prestone spells it Wire Drier whereas Permatex & Gunk have it spelled Wire Dryer.
Last edited: