• End of year community survey

    If you've been seeing any bugs, want new features, or have any positive feedback we'd love to hear it and we'll be putting together a plan for adding in these changes in 2023!

    Check out the survey

ModMaker 510 help

Status
Not open for further replies.

Trico

Senior Member
Mar 18, 2018
73
118
53
Aveiro, Portugal
strobelab.com
    Hello,

    I'm trying to build my first squonker and I have a question regarding ModMaker's 510.
    I see that there are 2 versions:

    V1:MM510 V1 Squonker Connector
    Micro: MM510 Micro Spring Loaded Squonker Connector

    Can anyone please tell me what would be the best choice for a Shapeways enclosure?

    MM Mech Squonk Box (18650) by RicModMaker on Shapeways

    Since I've never built a mod before (been using a Pulse BF since February) I'm a little confused about the advantages/disadvantages of each one.

    Thanks.
     

    Trico

    Senior Member
    Mar 18, 2018
    73
    118
    53
    Aveiro, Portugal
    strobelab.com
      judging by the box you getting,looks like the design will have a flat strip that gets pushed against the 510 positive ?? if that is the case you should get the 2nd link choice

      That's correct (flat strip gets pushed against the 510 positive), but I've just watched a tutorial video using the same enclosure and the 510 used was the V1 (using a MM510 Large Postive Nut), hence my doubt:



      Thank you for your reply.
       
      Status
      Not open for further replies.

      Users who are viewing this thread

        ')