MODS that can run RDA's that have coils resistance below 1 ohm

[Andre77]

I have a VAMO V5 and ITaste svd. Both are great MOD's and i use Nautilius, clear 30 and Kayfun with 1.5 to 2.5 ohms resistance coils on them. Both of these have a limitation as they do not fire while using lower resistance coils. I am new to rebuilding coils. I recently bought a dripping atomizer and rebuilding my coils. I prefer having low resistance coils on my RDA. Please suggest me a MOD that can fire lower resistance coils. The coils i have made are usually less than 1 ohm. ( 0.5 to 0.7). Please let me know which mods can fire lower resistance coils.

Thanks,
Andre

 

[abbysinthe]

Consider a mechanical mod if you're going that low. Just know that they offer none of the protection you get with a regulated mod as you've been using.

 

[Asbestos4004]

dna 30 mods. theres a ton to choose from. The VaporSharks are fantastic.

 

[InTheShade]

Yep pretty much all the DNA and SX chips can fire 0.5 and above. Of course, as abbysinthe suggested, you could always get a mechanical and run whatever resistance you choose.

Just remember that the only safety feature in a mech is you - so do your research about battery, coil and mod safety before you use one.

 

[v1k1ng1001]

Ipv2s should be out soon

 

[InTheShade]

Ipv2s should be out soon

SX350 chip I think in those that can go down to 0.2ohms...

To think not even 6 months ago everyone was freaking out about 20 watt devices.

 

[Markill]

Any mech mod will go lower than 1 ohms. Also, more expensive and "sophisticated" VV/VW will fire under 1 ohm, such as iPVs, DNAs, and similar

 

[Andre77]

I appreciate everyone's response . Thank you so much.
Andre

 

[EBates]

My cana dna30 claims to fire at .3ohms minimum. Ref the user manual I got with it. I've never tried to fire a .3 ohm atty so YRMV.