More Air Control

[Papa Hoyt]

I was wondering if anyone has thoguht of doing or has modifided the Collection tank to allow more air through the tank??

Every so often I get a 510 atty that is just to stiff while inside the tank. I have had some sucess with removing the O-ring inside the lid to allow air flow to come in that way.

The 510 I am puffing on right now is like a McDonalds milkshake in the tank but if I take the lid or the tank off it has a good draw on it.

SO has anyone been brave enough to add a hole or something to allow more air flow?

 

[inquisitorj]

Sounds like the air holes are plugged on you catch tank hoyt.

 

[Papa Hoyt]

thought that as well but they are clean, it happens from time to time just some atties are tighter than others and then once in the tank they are really stiff.

 

[inquisitorj]

You know, if you keep it is the same line you should be able to add 1 or 2 more holes.

 

[imeothanasis]

More holes will not give you more air Papa. Maybe more holes on the GGTS connector will do but I doupt. Connector has already 2 holes 1mm each witch are too big just for only air.

 

[Papa Hoyt]

More holes will not give you more air Papa. Maybe more holes on the GGTS connector will do but I doupt. Connector has already 2 holes 1mm each witch are too big just for only air.

My GGTS actually has 4 holes in the collector tank and 4 in the base of the connector and 4 notches in in the 510 connector at the top of the threading.

Irt really is just the atty but I have cleaned it twice now and it is not clogged it just has a tight draw while in the tank.

 

[Zoranth]

Popa, have you had your GGTS completely apart including the center pin portion? I am wondering if there is some debris inside the connector itself causing the tightness of the draw on an atty that does not have a tight draw outside of the UFS?

 

[Papa Hoyt]

Popa, have you had your GGTS completely apart including the center pin portion? I am wondering if there is some debris inside the connector itself causing the tightness of the draw on an atty that does not have a tight draw outside of the UFS?

I will go clean it again, I am not sure if if I detailed the connector or not but pretty sure I did.

P.S. this is not in an UFS it is dripper style in the collection tank.

 

[Zoranth]

Either way, UFS or standard it could cause the same problem in both

 

[Papa Hoyt]

Nope it has got to be the atty, I have experienced this before.

Weird though, it gets enough airflow without the lid on. The atty I just blew the other day was vaping quite well without airflow issues.