UFS help - No air flow

[hillock]

I just received my new UFS a couple of days ago. Unfortunately, I can't seem to get it to work. I couldn't get any air flow after fully assembling the unit. So I did it step by step. I put the bottom part of the tank. Then put in a new cisco 510. Air seems to flow through the atomizer. Then I put the middle section. air flow - check. Put in top section and top cap. No air flow.

I did this with no juice in the tank. I tried all configurations of juice control open/closed + air control open/closed. I tried different driptips in case the contour was affecting it somehow. The last thing I can think of was that the connector had a small dent, which might be completely covering up one of the atomizer holes. Bruce was nice enough to send me a replacement, and it is in the mail now. But even if it was covering one of the atomizer holes, I should still get SOME air flow from the other atomizer hole. When I pull, there is ABSOLUTELY NO air flow - not even a tiny amount.

If anyone has any suggestions, I'm completely open to try them. Thanks

 

[AdamAnd]

Maybe the collection tank has to much vasoline and it is blocking the holes check all holes.

 

[RippleInStillWater]

Did you watch the videos? Try different attys? BAck off 1/8 turn when attaching atty? I'm baffled......

 

[hillock]

I just wiped it clean. Although seems like maybe there might be something clogging the CTank hole. I'll check again later when I get a hold of a paper clip or something.

I watched all the videos, and have tried both diff atomizers and cartomizers. Didn't do the 1/8 turn until now but still no difference.

 

[RippleInStillWater]

Are the 4 air holes clear themselves under the control ring? My holes in the base have gotten clogged also, I had to ream them out to clean........

 

[hillock]

Yup, you guys were right. The holes were clogged badly to the point I thought the manufacturer didn't make any. All good now. Thanks!

 

[dspin]

Glad you got it working.