more help needed

[Lallii 44]

so since my KANG is more or less out of order i wanted to use my Vapresso Mini changed the ceramic coil as usual .and wow what a burning hit and smell i got........decicid to put in other brand ne coil......same problem......i can only vape it on very low voltage the moment it goes up to 15 plus it starts having this burning taste and smell
what could this be???

 

[QcVaper]

Did you check the recommended wattage on the coils before putting it on high wattage ? Did you prime it,did pre puffs, let the tank sit? Also always start at lower wattage when you change a coil to slowly break it in.

 

[dc99]

Ceramic coils need longer to prime than regular coils and I have never got one must past 30w. If you run a regular coil at say 40-50w, the same tank with a ceramic will most likely be around 20-25. They do put out a lot of vapor considering the lower wattage you run them at

 

[Coastal Cowboy]

Ceramic coils need longer to prime than regular coils and I have never got one must past 30w. If you run a regular coil at say 40-50w, the same tank with a ceramic will most likely be around 20-25. They do put out a lot of vapor considering the lower wattage you run them at

Yep. My Estoc Mini tops out at 40 Watts with the 0.4. But my gosh is the flavor awesome. I like this tank so much, I ordered the big'un.

 

[Chodi]

Suggestions above aside this is a known problem Vaporesso produced a lot of defective coils. In fact most of their coils for a long time were all defective. It could have put them out of business. They came up with the solution and packaged it with their newer EUC ceramic coils using replaceable sleeves. I have had experience with their problem period and horrible dry hits. Put the tank away then much later tried the EUC ceramic when it came out. That was not only the end of all the problems but also the beginning of an extraordinary vape experience. Never any further problems and the new EUC coils last for months.

 

[Chodi]

Suggestions above aside this is a known problem Vaporesso produced a lot of defective coils. In fact most of their coils for a long time were all defective. It could have put them out of business. They came up with the solution and packaged it with their newer EUC ceramic coils using replaceable sleeves. I have had experience with their problem period and horrible dry hits. Put the tank away then much later tried the EUC ceramic when it came out. That was not only the end of all the problems but also the beginning of an extraordinary vape experience. Never any further problems and the new EUC coils last for months.

 

[Lallii 44]

Did you check the recommended wattage on the coils before putting it on high wattage ? Did you prime it,did pre puffs, let the tank sit? Also always start at lower wattage when you change a coil to slowly break it in.

hi thanks for the input......i did prime and gave it pre puffs but no i did not check the wattage since the coil came out the same pack then g one before.......

 

[dc99]

Is this the tank that uses the ccell coils? If it is the only one of them I like is the .6 SS. I still let it soak for a good hour before I fire it. If it is then any coils that work in an atlantis will work in it.