I've noticed a lot of stores online and in my area sell 3cc syringes and 22g needles for basic to pro level Kit needs. It can simply be used to spray water on an atty head to clean off VG gunk, fill a carto, or help separate the loops in wiring so you can re-wick or just set a slightly used head to right. I have found that I prefer the Curve tip syringe. They aren't as useful for the Pro level jobs, but they are more comfortable for a moderate user like me. Still get good pressure to spray the VG off, Easier for me to fill a carto with than a hard flat needle, never have to worry about dropping it and it ending up through My shoe and into my foot (Sadly, has happened more than I'd like to admit.) Best part, I just asked for one from a local small vet clinic and they gave it to me. Nothing beats free. The small tip fits into most dropper heads so if a bottle has one you can draw right from it without fear of punching through and putting a hole in your E-juice bottle. The slightly pointed tip is good for getting juice out of a battery female connection without having to make contact with the pin. It has become one of the most used items in my at home, cleaning/refilling kit. What are other supplies that you have and can't live without, but rarely see in others kits?
- Status
On thing I use to flush my atty heads is a water pick after I've put the head in my jewelry cleaner for a while. Syringes work damn good to. I found that the smaller bore needles will produce a harder jet and really flush good. Also alcohol soaks help. you just have to flush good after that.
I have only rinsed my tanks in warm water. gunked up coils get removed and replaced immediately.
I must say I thought this might have dug up some other tricks of the trade from some of the long term vapers. I know I have read a lot of threads dedicated to One Fancy trick, but never did I come across a thread with Lots of little tricks to get your PVS working the way you want it too. I followed one the other day on Not tossing out EVOD heads when the silica burns out, but rather get em clean and replace the silica with Cotton from a Q tip. This would have been great to read the day before, because the EVOD atty heads I was sold do not work with the 2 evods I have. I get a lot of fluid coming up the mouth piece, and constant flooding. So if you have a BCC and don't have a replacement when the head gives out (or notice that the head on has lines going down the while part of the breathing shaft, and the replacements have them going only half way down, Use the top of a clean, unscented, uncolored regular cotton swab. Pull it off to give it the shape and length of the silica (You can use cotton string too, but depending on where you get it you may have to boil it to get dyes and waxes off) Taper one end and send it through your coils. It's ok if you have a little room, because the cotton expands. Give EVOD and any other BCC time to fully fill before vaping (Dry burn on silica, no biggie. On cotton, very bad.
- Status
Similar threads
