So i got this mutation x v3 .. and everytime i build on it with 26g it always comes loose. I mean i install the coils right then i reposition them using a screw then it became loose. Even if i tighten it it and if i try to tighten the scew more it snaps the wire. I mean whay is the problem ? I didnt have this problem on mu cloned turbo v1 . Can anyone suggest a solution ? Thanks. Sorry for bad english .
Mutation v3 loose .
- Thread starter spitzer26
- Start date
- th_trl_thread_readers 0
- Status
I would try replacing the screws with some hex socket grub point set screws. Them Chinese screws ain't what they might be. I have done this in my Mutation V4s, and my MT tanks by the same company. I do not know the thread spec for the V3, but the V4 and the MT use M2.5 x 4mm. I found them on eBay, but I can't get the link to copy. And if the screws are cutting the wire, it may be the posts below the wire holes are hollow. Fill them up to the bottom of the wire hole. You can stuff them with vape wire. I use a piece of 1/16th inch stainless shafting cut to the length that just fills it. I bought that at a model company.
- Status
Similar threads
