Hey everyone i recently had just bought a mvp v2 and got a cartmomater tank and for some reason my cartos read none when it ry and check them on my mvp but on my tesla and silverbullet they fire fine does anyone know why this may be happening and if this is in the wrong forum thread sorry in advance!!
MVP V2 question???
- Thread starter Talyns1369
- Start date
- th_trl_thread_readers 0
- Status
it reads none this is also happening on my friends svd is it possible the innoken products dont fire cartomizers very well?
I had the same problem with my cartotanks on the MVP v1. On some MVP's the connectors for the cartomizers (Ikenvape) and the connector pin on the MVP don't make electrical contact. I only had this issue with cartomizers, as all my clearomizers worked flawlessly.
If this is a huge issue, you can pull the connector pin up slightly by gently prying it up with a tool. I didn't bother doing this with mine as I received the MVP for free in a raffle and planned on paying it forward to a close friend just beginning to vape and knew she likely would only use clearomizers on it.
I've read of one MVP owner who ground the inner connector ring down on the MVP so to not affect the center pin height.
If this is a huge issue, you can pull the connector pin up slightly by gently prying it up with a tool. I didn't bother doing this with mine as I received the MVP for free in a raffle and planned on paying it forward to a close friend just beginning to vape and knew she likely would only use clearomizers on it.
I've read of one MVP owner who ground the inner connector ring down on the MVP so to not affect the center pin height.
Last edited:
Or you can slightly file down the skirt that surrounds the center pin on your MVP. I had to do this for an RDA to fire on my version 1. Took only a few minutes and works great now.
hmmm that is very strange itd have that issue because like you clearomizers attys etc work fine but its just the cartomizer doesnt register with the device itself and it also happens on my friends svd so the only option is too try and pull the connector up or are there other tricks to get them to fire?
The skirt=the beauty ring/collar/plinth that goes over the ego threads/outside threads on MVP to just serve as a cosmetic and protective application when using a 510/inside threads on MVP atomizer.
oh ok i got ya do you think maybe trying a 510 to 510 connector on the device then trying to carto could help make it fire??
Assuming you're using regular boge cartomizers, have you tried to take it out of the tank? This is one reason why I like to use syringes for cartomizers, easy trouble shooting with tanks. Your tank could be too low, and the O-rings are gripping it so well that it isn't budging from the force of screwing it down on the PV.. Try pushing your carto down just a tad to see if that will make contact. If not, I will assume that it is the actual firing pin on the MVP that is too low for the cartomizers, like baditude referenced..
Alright awsome thank you suspect for the responses i have taken the carto out of the tank and tried to see if that would make a difference and it didnt so im assuming id probaly need to try pushing it down and see if that works
- Status
Similar threads
