My first .19ohm build.
- Thread starter Greg095
- Start date
- th_trl_thread_readers 0
- Status
26g parallel, 5 wraps on a 3/32 drill bit. It's HOT, still need more airflow.
Sent from my iPhone using Tapatalk
Very cool! Yeah I just did the same exact build on my Brass Monkee ....26 ga. dual parallels for .2 Ohms.....it gets VERY hot!! haha
I did a similar build with 26 gauge, but 7/6 wraps around a 5/64" drill bit at 0.20 Ohms. Wasn't too happy with the flavor against my 24 gauge build.
Sent from my SM-G900P using Tapatalk
Sent from my SM-G900P using Tapatalk
heres my first 0.19Ω. its evened out to 0.2 shortly after building. the vapor is nice n warm, but not incredibly hot. its 26g kanthal, 10 wraps each, ID 3/32". the 6 mega sized (7/64" a piece i think) air holes keep the coils properly aerated. plus i have a two-piece drip tip that insulates although the heat sink top cap is already effective. its the igo-M rda. im a huge fan. clouds upon clouds.
- Status
