My new coil dilemma

[dykealiscious]

Ok so I put 12 wrap twisted 30g on my nimbus, which is so small I had to uncoil to 11, but the center post hole is so small that I couldn't thread both coils into it. I ended up wrapping the second coil positive to the screw and tightening it down that way.

It gauges at just over 1ohms. It works. Its my first nimbus build.

A) was that the right thing to do?
B) why is the TH killing me!
C) should I go back to microcoiling nontwisted 30 or go down to 32?


Any other pearls of wisdom? Sooner than later, I'd like to get a good vape in tonight.

 

[Obsiden]

You could do parallel 30 gauge and make sure you pull the coil closer to the air hole

 

[dykealiscious]

Now THAT I have no idea what to do.

I did just build a dual 30g 13 wrap that's clocking at 1.43. About to test it.

Sent from my EVO using Tapatalk

 

[Obsiden]

Parallel coil is just two pieces of wire wrapped so they are next to each other

 

[Obsiden]

 

[dykealiscious]

I tell you what, with 3 posts and a small compartment that Nimbus doesn't have a lot of space but I managed to make it work. If I try this again it may just be what I go to, and the vape is so cool and flavorful that I can barely tell I'm vaping until I exhale so maybe I did something right! That parallel coil looks badass. Hmmmm.

Sent from my EVO using Tapatalk

 

[dykealiscious]

Parallel coil is just two pieces of wire wrapped so they are next to each other

So how many wraps is that?

Sent from my EVO using Tapatalk

 

[Obsiden]

it was 10 wraps around my smallest drill bit...it comes to .4 ohms

 

[Obsiden]

Rip tripper has a video on youtube on how to wrap a parallel coil

 

[dykealiscious]

Great I will check it out. The factory coils were at just under .8 and it was so harsh I couldnt even get the Vape even a little without hacking up a lung. Is that what sub ohms does?

Sent from my EVO using Tapatalk

 

[Obsiden]

It probably the air hole line up with the coil

 

[Cloud Junky]

Try taking lung hits, it is an art. do not take a mouth to lung. Inhale from the atty to you lungs it gets better and better every time.

 

[dykealiscious]

Try taking lung hits, it is an art. do not take a mouth to lung. Inhale from the atty to you lungs it gets better and better every time.

Okay! Thanks folks!

Sent from my EVO using Tapatalk

 

[JohnnyDill]

Rip tripper has a video on youtube on how to wrap a parallel coil

-Rip Tripper has a video on YouTube on how to wrap EVERY coil.

 

[chrisj3982]

About the throat hit, what nic level are you using? Vg/pg ratio. When using my dripper, anything over 10mg kills my throat, an I run either 80vg/20pg or 90vg/10pg. When I use my taifun gt or pro tank I use 24mg, 60vg/40pg


Sent from my iPhone using Tapatalk

 

[dykealiscious]

About the throat hit, what nic level are you using? Vg/pg ratio. When using my dripper, anything over 10mg kills my throat, an I run either 80vg/20pg or 90vg/10pg. When I use my taifun gt or pro tank I use 24mg, 60vg/40pg


Sent from my iPhone using Tapatalk

12g but I've perfected my coils so they come out at 1.5 on a dual and its perfect. I dropped it down to one ohm by using premade twisted 13 wrap 30g and it was 2 harsh. Twice built with the 1ohm and I got the same prob.

Sent from my EVO using Tapatalk

 

[classwife]

Moved to Coil Builds from the Modding Forum

 

[dykealiscious]

Moved to Coil Builds from the Modding Forum

I could only post in the new forums when this was first posted. I'm pretty sure at this point youve got something against me.

Sent from my EVO using Tapatalk