My Pro tank 3 is leaking

[RogerWilco357]

I have the Pro tank 3 on the Lavatube and it seems to leak or and have poor draw any ideas?
I have switched out the atomizer and same thing . blew it out and all the liquid came out on the napkin. I got a replacement it worked well for a day or two then refilled it and bamm same thing. anyone else having these issues if so how did you fix it?
my cheap tank i bought like for 7 bucks is vaping circles around my 20 dollar PT3. but it is a top fill unit not like the bottom coil the PT3 has ...well thanks
Roger

 

[happydave]

are you missing an o-ring / gasket? look at pics of the PT3 online and see how it compare to yours.

 

[dooglez]

I had the same problem with the pt2 didn't really wanna touch the pt3 cause of all thoes problems but I noticed if I put it on my Nemesis (clone) then I had no problems at all cause of the little air flow control on my mech. its a big hit or miss from all that I hear about them, plus I think it has a lot to do with wat device u r using it on, try it on a different one and see if you get the same problems
hope this helps any

 

[LX1X]

Poor draw = you more likely sucking up the juice.

Resolve the draw issue may solve the leak. Leak probably you flooding the coil camber.

 

[ckquatt]

My pt3 does too. Really hard draw on my SVD, leaking, gurgling. I've tried everything I know of to fix it. O-rings, atty fixes, thicker juices, nothing works. I just threw it in a drawer.
I don't think its an atty problem cause I use those same attys in my protank 2's with no problems. Its got to be with the unit itself.

Sent from somebodys phone I found using Tapatalk.

 

[Topwater Elvis]

Be sure the head is tightened firmly into base, check orings, blowing through a bcc to clear a flood will make it flood worse.

Either manually dry the air tube or turn it upside down hold napkin over base and give it a couple short firm blows while upside down to clear flood. Then leave it upside down for a few minutes to equalize pressure inside tank. Probably have a little leak out the drip tip, twist napkin and shove it in the tip to dry it.

I agree with the above, fix the air flow issue and the flooding might lessen.

Better yet, smashing it with a sledgehammer will fix all prostank problems.

 

[RogerWilco357]

man i am almost there with the sledge in hand. I was toying with it again cleaned it up and this time I noticed the rubber cap on the atomizer was not seated correctly so removed it and placed it flush and it seated worked for a minute or so so put more juice in the tank and back to gurgling . so think the rubber isn't seating correctly and may be the problem will tinker with it a bit more hopefully it will work .thanks