Nano dragon coil troubles

Status
Not open for further replies.

IMFire3605

Ultra Member
ECF Veteran
May 3, 2013
2,041
3,148
Blue Rapids, KS, US
I had the same issue, they make great flavor and vapor first couple hits after a fresh drip, but after that they burn, throat hit real bad, before scorching. Pull the top cap, still see wet wicking, but around the coil it is completely dry. Wasn't much impressed, moved back to at the time, IGO W V1 era, resting the coil down onto the cotton bed
 

DangVape

Full Member
Verified Member
Jul 9, 2015
54
62
45
Montreal, QC, Canada
I'm doing single 24 gauge nano coil 0.45 ohm, on mech so about 30w -+ depending on the freshness of the battery

I found that the wicking method I see most in YT video angle up where you leave one end of the coil out and cover the rest give me nasty dry hit when I run "low" on juice.

By watching it without the cap, just hitting and blowing on it, I could see that the exposed end dry early and start to spit burned gunk

I prefer horizontal with a cloud of wick underneath it, I put enough wick so it's half to 3/4 buried and leave the top part completely open to air.

Here on my Veritas.
2dqu60y.jpg

rvis1k.jpg


I use Drago cotton wick not sure if that make any difference at all but it's super absorbant.
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread