Nautilus Mini Issues...

[GccTxs67]

Losing love for my nautilus Mini...

Air Holes getting so clogged I can't even inhale without piratically sucking the chrome off my drip tip! I cleaned it, I cleaned it, i cleaned it....Works fine for the first 20 minutes or so, then nothing.

And it leaks, every time I pick up my mod it's sticky. I don't even know where it's leaking from, all i know is I clean off my mod until it's not sticky, set it down, 20 minutes later I pick it up and it's sticky again (and has no air flow)

Thoughts?

 

[Amy87]

Have you checked to make sure its not a clone? I'm sorry I have no other suggestions, I've had nothing but good experiences with all my Nautilus Mini's ( I have 4 ). I have never experienced a clogged air hole or a leak.

 

[GccTxs67]

It's not a clone.....

I soaked it in hot hot soapy water and took pipe cleaners to every nook and cranny, made sure all the seals were tight and it hasn't had any issues for the last couple hours. Maybe it just needed a good scrubbin.

 

[Diver9543]

I had that problem and I had the top seal upside down.

 

[Rixsta]

I had that problem and I had the top seal upside down.

Yes good call, this happened to me too, although it doesn't like high vg juice either..

 

[lovemytank]

Maybe you have some bad coils that arent getting seated all the way down? Maybe you have no arms and can not tighten the coil enough? Just kidding because that tank also has been a bomber for me, all 4 of them . I can make that joke because I lost both arms and had vaping devices stitched to my neck.

 

[drysprocket]

Yeah it could be the coils. But one thought- almost all of my naut mini problems went away when I got the metal sleeves for them. For whatever reason...they just perform better. Might be worth the 8ish bucks if you like the look.

 

[Amy87]

Yeah it could be the coils. But one thought- almost all of my naut mini problems went away when I got the metal sleeves for them. For whatever reason...they just perform better. Might be worth the 8ish bucks if you like the look.

You're probably right. I didn't mention it above, but I only use the metal sleeves too. I have all the glass tubes that came with the original set ups, but I never use them. I was always afraid they would break trying to unscrew the base, since it can be rather stubborn at times. With the metal you can get a good solid grip to take it apart without worrying about the glass shattering in your hand.