need a 10mm or under pushbutton switch

[doctadrea]

The part inside the mod can't be over 10mm either. This is a teeny mod!
I tried looking myself, but I don't know enough about the terminology to find what I'm looking for. I need it to go through the body and screw in with washers or otherwise attach. I usually build around 2.5ohms or up, so I'll be pushing under 1.7amps max.
Ideally, the button would barely stick out. Smaller is better.
Please give me suggestions or links.
SPST Micromini Toggle Switch : Toggle Switches | RadioShack.com
This was a good size even though the switch is way too long, but I don't want toggle because... well, that should be obvious.
If I'm leaving out details you need to know, tell me. I am far from an expert on switches, as I'm quickly finding out.
Also, I'm not above bribery. Vacation advice, help with your economics homework, you name it.

 

[Recycled Roadkill]

Radio Shack has a decent selection of momentary push button switches. Assuming you've got a store in Maui I'd suggest you check it out. There's lots of stuff out there that may fit your specs.

Otherwise ebay or a local store that caters to electronics enthusiasts. Good luck in your search.

 

[Jackstand Johnny]

I ordered some stuff from madvapes.com. Theyve got a really good selection of switches there. Check under the DIY section.

 

[D. Waterhouse]

Switches The two I have are the C&K Components 3A Black Push Button switch which will work if you bend the tabs out (careful with that so you don't break the body of the switch) and the Mini Push Button Switch, Black which has the same dimensions below the nut but will stick out less but has an awful low rating (.5 amp). You might want to pick up a few of the Mountain Switch, Red Push Button Metal Body 3A to try also.

 

[DreamWithin]

Moved to Modding forum

 

[doctadrea]

Excellent! Ordered and done. Thanks for the advice.