need help on assembling AGA-

[mavieboy]

ok so this morning i gt my aga-t and then i when to disassembled it to soak in hot water, just to make sure its clean. then when everythings dry, i cant seem to find a good review or assembling on youtube, i dont know where those mini rubber O-rings fit where and so. need help guys asap =) i wanna try this rba asap T.T

 

[Domtine]

My guess would be in the center hole of the top and bottom caps to insulate the center pole.

 

[mavieboy]

My guess would be in the center hole of the top and bottom caps to insulate the center pole.

i would try to search online more and figure it out, any thanks for replying, im nervous about the ss mesh, havent tried it before too T.T

 

[oOSubliminalOo]

Don't rush on your first SS mesh coil. Make sure you oxidize properly preferably before and after you roll to ensure it will not short.

 

[mavieboy]

Don't rush on your first SS mesh coil. Make sure you oxidize properly preferably before and after you roll to ensure it will not short.

i havent even fit and assemble all the parts, i cant find any ppl on youtube who remove everything and fit back one by one

 

[pleaselah]

i havent even fit and assemble all the parts, i cant find any ppl on youtube who remove everything and fit back one by one

Yes there actually is. I can't seem to find it but its around 30 plus mins

 

[lunz84]

i think you can see this video ***AGA-T Genesis Rebuildable Atomizert & FREE Contest Giveaway*** - YouTube

 

[mavieboy]

i think you can see this video ***AGA-T Genesis Rebuildable Atomizert & FREE Contest Giveaway*** - YouTube

someone showed me that video alr =) i assembled it alr woohoo

 

[mavieboy]

Anyone knows how often a rba should be cleaned? and how long can a ss mesh last?

 

[Okay]

Once it taste funny, the coils start to gunk up with black stuff....start rebuild.

 

[ussr]

usually u decide by looking at the coils and the mesh.

Remove mesh to see if its gunked up or burnt thru.... if so may consider reusing after brushing it in hot water or juz roll a new one.
Do a few burns on coils without mesh to remove gunk on coils.

I feel that if you have time just remove mesh after 2-3 refills depending on juice, dry burn the coils to clean it and u can prob last way longer.

 

[Domtine]

for my DID I usually rebuild every 3-4 days. didn't bother to dry burn or what ever......

mesh and wire does cost that much to begin with. once you get the hang of making them u can get one done in under 10mins.

 

[dwsp77]

usually e mesh wick can keep re-using until like curry says.. e wires just recoil lah since so easy - mesh i'm more lazy to do so will use until cannot use..

 

[hakeiym]

Dyou guys re-use the mesh on other flavours?

 

[madhero]

of cos... wash with tapwater, flame, good to go...

 

[hakeiym]

i did just that, but there's a slight taste of the previous juice. and the new juice on my genny start to change colour

 

[madhero]

Err... Wash with tapwater, thoroughly? Or you can soak the mesh in alcohol.
As for changing color, when the mesh is used for a longer time, juices tend to get darker. Sometimes you can see the darker layer at the bottom. No worries about that, it's normal.

 

[hakeiym]

ahh i see, think i shld try the alcohol method, thanks MH!!