Need help. Protank 2 problems

[Rburne1]

Okay, I just bought a new coil head for my PT2. When I go to take a hit it is a real hard pull, no vapor comes out and if I try to pull any out it just comes out as the juice no vapor at all. Help!


Sent from my iPhone using Tapatalk

 

[irwink]

Is it a genuine Kanger coil assembly or generic? From my experience generics perform poorly. Genuine or otherwise it's also possible that you just got a defective one.

 

[Rburne1]

I got a genuine coil from the Vapor store in my town. I know that it is sorta common to get a defective one but I've never heard of anyone else having that same sort of problem.


Sent from my iPhone using Tapatalk

 

[Mark Anthony]

Check out the Kanger aero base on their website.... I ordered a few of them for my ProTank 2's. They allow you to control your air flow for about $5 a piece. They replace the base that originally comes with your PT's.

 

[Rancor0681]

Is the coil head screwed in tightly. I've had a similar issue when putting a head in in a hurry thought I had it screwed in all the way but wasn't. Got nothing but gurgle and juice no vape

 

[crxess]

If the Draw is extremely tight - The rubber seal that the Center pin sits in is Bulging and Blocking air from the Side holes. Simple check. turn Tank back out 1/4-1/2 turn. If it gets the Draw back, that s the problem.
The grommet can be trimmed carefully with a thin Razor knife to all air to pass.

First chance, replace the Tank Base with the AeroTank Base and that should permanently fix the issue.

 

[Rburne1]

Crxess, thank you! That was the problem all along. I'm glad that it wasn't a bad coil.


Sent from my iPhone using Tapatalk

 

[crxess]

Glad to help
Now go, Vape, Be Happy!