Need help re-anodizing etching!

Status
Not open for further replies.

JoelB94

New Member
Jan 25, 2014
2
0
Dover, MA, USA
I just got an account here and I need help. I stripped off the nice black anodization on my Stingray mod. I was using Brasso and it got rid of it. The etching on the brass piece is still there but the black is gone. Is there anything I can do to get it back? Help would be greatly appreciated!

Edit: To clarify, I have the regular JD Tech Stingray, not the limited edition one with all anodized brass.
 
Last edited:

*deleon517*

Ultra Member
ECF Veteran
Verified Member
Jun 29, 2012
1,340
476
s. florida
you may or may not get lucky with a answer here. once you get too 5 post you will gain access after about an hour, to the other sections of the forum's. the modders section would probably yield a better result but may take a day or two as that section isn't as active as this one. Hope everything gets sorted out for you.
 
Status
Not open for further replies.

Users who are viewing this thread