Need Help to finish my PV...PLEASE

[UA72Riddle]

I bought this switch for my tube mod, and I know I have to have a regulator or something else to go with it because of the lower rating. I mainly vape @ 3.7V and would like to occasionally use 2 3V stacked. I dont use attys or cartos...using a design I found on the modders forum similar to the coil design of CE2s....so I can adjust my ohms by adjusting my # of wraps, and wire mesh is my wick.

I have that switch and this regulator, but when I soldered them together I get no response. I soldered a wire from my switch to the in(assumed) post, then from the out(assumed) post I soldered a wire to the POS+ post. Is this the wrong regulator, or just the wrong set up all together. I bought this regulator to go with my switch from reading reviews on the site about my switch. Thia is my first mod, and I really want to get the switch installed so I can take everywhere I go without worrying about it going off in my pocket. Thanks everyone in advance!!

 

[Minus1724]

that regulator need a
+ from battery to switch,
from switch to the left leg, on the regulator
- to the middle leg on regulator
- from middle leg on regulator to atty
+ from the right leg on regulator to atty center

but I dont think that switch is going to hold more than a month vaping. The switch is rated to 50mah and at 5V. your pushing above 1000mah

 

[asdaq]

Riddle, a reg with a control pin for the switch works well with that switch. The reg you have needs a bigger switch really.

 

[UA72Riddle]

Thanks Asdaq. I dont really know what goes to what, and how to pick all of that stuff out. So unless someone tells me, probably 8 out of 10 times I will get the wrong thing. I just pick the one with the highest rating I could find in the smallest package. How about this one? A little smaller, lower amp rating...but the same 5V rating.

Riddle, a reg with a control pin for the switch works well with that switch. The reg you have needs a bigger switch really.

 

[Sci]

I posted this in MVs section, but I'll put it here also. You'll be in the same boat with that one. See if this one will fit. It has the control pin that you need for the switch you want to use.
Take a look @ this thread on MVs board about how to wire it up.