Need help with diy dna20

[okdokiez]

Hi all kindly need advise from expert. Just now done wiring for dna20 but the problem when i press firing button nothing happen and not firing.Remove wiring from 510 connector and press again still nothing.Supposedly when wire remove from 510 it should check atomizer error come out rite?but no respond.click 5 times screen locked as normal..anyone pls help..thanks

send from my old school phone

 

[bapgood]

The dna needs to measure a load before it will fire. So you need to hook up an atomizer of some kind before it will fire.

 

[okdokiez]

Will try..thanks bapgood..

send from my old school phone

 

[bapgood]

I just re-read your original post, you should get a check atomizer message. Someone else recently had this issue and had inadvertently wired the 510 to the fire lugs and the fire button to the out lugs. If you happened to do this it might explain why there was no check atomizer message.

 

[okdokiez]

Output wire to 510 connector n fire wire to tactile button..all check..

send from my old school phone

 

[okdokiez]

Same result nothing when firing button press whether on board or using switch button..give up already..hahaha

send from my old school phone

 

[bapgood]

I hate to say it but it sounds like you may have a bad dna board, contact Evolv and they will likely replace it.

 

[okdokiez]

enclosure waiting maybe dna 30..

send from my old school phone

 

[okdokiez]

Thanks bapgood

send from my old school phone

 

[okdokiez]

Actually i got another spare dna20 chip but at the moment don't have a mood to do little tiny soldering job.hahaha..

send from my old school phone