Need MVP2 Topper Suggestions

[cantplay]

New vaper with MVP2. Reading lots here. The information is fantastic, but want to put an order in today. So I'm looking for quick suggestions. I have a protank2 and clear30 right now. Both working well.

It goes without saying I am looking for the "best" performing in the below categories and understand there are different opinions. I am looking for help identifying:

1. An atomizer for MVP2 to experience and try out flavors at the B/M
2. A nano clear to swap flavors at home easily
3. A small, low profile tank that will allow me to front pocket the mvp2 without worrying about breaking or snapping off the topper when I sit or bend over (halfling 15mm?)
4. A low profile drip tip to go with #3
5. Anything else that vets think is a must have with the mvp2

Will also throw out only 3 grits yesterday from a pack a day guy!

 

[JTrain23]

As far as a "must have" for the MVP2, in my opinion, is the Aspire Nautilus. However, it isn't the smallest tank out there. Their ET and ET-S are fantastic tanks as well and won't break the bank. I get them at my local B/M for $9. The Nautilus is gonna be in the $35 range.

 

[cantplay]

Thank you JTrain23! I looked into the Aspire Nautilus a little and will look into the others you suggest. I'm trying to get more up to speed on how to handle the tanks, changing flavors in them, cleaning them, maintenance and whatnot.

 

[RugerRob]

I just run protank II's on my MVP 2.0. I have Iclear 30S and Protank Aero's but they are too tall, protank II is shorter works well and haven't had any issues with them to day, just don't crank down the atomizer too hard. I also have an aspire bdc glass/stainless steel covered tank that works well on the MVP as it won't break if I'm on the go and drop it or something.

I just the IClear 30's on my VTR and I use the Protank Aero's on my Xgun.

 

[DetraMental]

I like the Halfling tank from IBTanked on mine as well at the standard 22mm tank. These are cartotanks and easy to use when done properly. You can get a beauty ring to make them look flush.

 

[Buggainok]

I started with the Kanger Evod kit and had good success vaping. When I got the MVP, I found the Evod clearomizers worked well on the MVP also. They fit nicely, and don't stick up very far, if you want a low profile.

The Evods are plastic though and may be a concern with "tank cracker" juices. I also like using the Smok Tech Pyrex Aro tanks with my MVP. Here is a link to them if you'd like to take a look. They hold more juice than the Evods, and are made of glass:

Smok Tech Pyrex Aro Tank

 

[Madmullet]

I have a Aspire Nautilus that I enjoy. It works well and the factory heads seem to last a while. I also run ProTank 2s with the upgraded airflow base and I re-build my own heads at 1.4 Ohm with cotton that give me a great flavor. But, as of late its been nothing but KayFun, Russians and clones for me. My go to pocket set up is a Mech mod with a 18500 bat and a RBA dripper and a 10 ml bottle of juice. I work on construction sites and I need the added ruggedness of the Mech mod and the dripper. It also makes for a nice compact package my set up is just as wide as my palm with a shorter drip tip. Its nice I can jsut throw in a few drops vape and get back to work not spend all that time burning a stinky old smoke. I keep tyring to convert the outhers guys I work with but I dont think they want to give up "Smoke Break".