Long story short... I'm not sure if over-tightening or dropping my vape caused this gasket to break or what, but at first the juice started going too fast... and then sometimes after changing the battery, the switch would get super hot, so I'd have to take it out and put it back in. It would usually only get hot on the first try, and then the second try it would be normal. Eventually, the switch got hot on the second and third times of putting a fresh battery in.... so I researched that and found out that there was a short, so I should "check the atomizer".
Found out that the original gasket is broken between the pos & neg center pin connections of the Aspire nautilus. I used a small rubber band to make it "functional" enough that it didn't overheat, but it is definitely still leaking juice. This is nuts to me, because the air holes are on the side. I don't understand why air is going thru the center pin, but whatever....
Where can I get a gasket??
Found out that the original gasket is broken between the pos & neg center pin connections of the Aspire nautilus. I used a small rubber band to make it "functional" enough that it didn't overheat, but it is definitely still leaking juice. This is nuts to me, because the air holes are on the side. I don't understand why air is going thru the center pin, but whatever....
Where can I get a gasket??
