Nemesis clone...little cylindar pin fell out :(

[xklipx]

I was trying to adjust the fire cap/bottom piece.....whatever you call it....and the little pin popped out. Thank god I was sitting down and someone else was above me so I was able to retrieve it. My problem is...how do you put it back in? I see that there are grooves that line up but when I place it in there it doesn't seem to fit. Anyone know how to fix this?

 

[gpjoe]

Unscrew the firing pin, but make sure you hold the switch together, there is a spring the may fly out of you don't secure the two switch parts. Now you should see a small groove in both of the switch halves. Line those up while holding the two pieces together, slip the pin into the slot/hole, and screw in the firing pin.

 

[xklipx]

i tried that (i think) as you said...but the pin sticks up interfering with the post that is adjustable.....trying again with tweezers....brb

 

[ScottChensoda]

If at first you don't succeed try and try and try again is all I can offer. It does fit as proven by the fact that it fitted in there in the first place. Try lining up the two grooves and then offer the pin to the formed hole. If it doesn't go straight in then try the smallest of movements of either the pin and/or grooves.

 

[VaPreis]

Once you get the pin back in, keep that switch contact tight. It is not intended to be adjusted, and will cause problems if left loose.

 

[ScottChensoda]

Remove the adjustable pin then try. There, you've done it. Well done.

 

[xklipx]

Got it! Thanks gpjoe! Have a beer on me my friend

I didn't remove the adjustable post first, last time. Thanks for the speedy help everyone.

 

[gpjoe]

Got it! Thanks gpjoe! Have a beer on me my friend

I didn't remove the adjustable post first, last time. Thanks for the speedy help everyone.

Nice. Glad you got it fixed.