New clearomiser

[crxess]

Personal results vary from everyone. Remember some hand assembly and QC play into effect. Some have complained of Protanks over wicking and others work perfect. Many factors come into play. Learning and adapting is the most economical answer.

Flavor wicks - Kanger have short wicks sitting on top of the Wick wrapped by the Coil. Should be 2 small wicks. Thanks to poor QC some have had 3(would not wick properly) others only 1(flood like crazy with a thin juice) Some, the wicks are placed improperly causing Gaps.

By wiggling the pipe on the wick assembly you can remove it and replace/correct these 2 wicks. reassemble and test.
Nice thing is you don't have to dump a Kanger to work on the wick. Just carefully place it somewhere upside down.(and don't bump it)

 

[philrab66]

Personal results vary from everyone. Remember some hand assembly and QC play into effect. Some have complained of Protanks over wicking and others work perfect. Many factors come into play. Learning and adapting is the most economical answer.

Flavor wicks - Kanger have short wicks sitting on top of the Wick wrapped by the Coil. Should be 2 small wicks. Thanks to poor QC some have had 3(would not wick properly) others only 1(flood like crazy with a thin juice) Some, the wicks are placed improperly causing Gaps.

By wiggling the pipe on the wick assembly you can remove it and replace/correct these 2 wicks. reassemble and test.
Nice thing is you don't have to dump a Kanger to work on the wick. Just carefully place it somewhere upside down.(and don't bump it)

Thanks again, just have to try and find some wick.

 

[magicmyst]

I have two eVods and haven't had any problems with gurgling or flooding.

Did you check to make sure that the coil is screwed on tight to the base? That would be your first step. Some people say adding wick above the stock wick can help with flooding/gurgling, from my reading around.

Yep- checking that the coil is securely screwed in has solved this for many. There's another good thread about this here. I have 4 EVOD BCC clearos (and another 2 on the way) and have had zero problems with any of them using 80PG/20VG.

Rob