New mods

[Newtothevapelyf3]

juSt picked up my cuboid mini. I have a aspire cleito tank with a .4 ohm coil. I'm running it at 58.8 watts and it says it's at 5.03 volts. Is that bad?

 

[Baditude]

Do you mean "Is this safe"? What do you mean by "bad"? Explain yourself.

The Cuboid is a regulated mod, so it has protection circuitry. Any condition that might be deemed unsafe (ie short circuit, atomizer resistance too low, etc) would cause your mod to display some sort of error message and it would refuse to fire the atomizer.

 

[juicynoos]

As said, you should be fine from a safety angle if that is what you mean? The tank (coil) and battery are working within safe limits. The subjective stuff is whether or not you find vaping close to 60 watts enjoyable with that setup.
Higher power/voltage will require a juice where the wicking keeps up so you don't get dry hits and your airflow might need some adjustment to where you feel comfortable from a heat standpoint.
Other than that you should be all good.

 

[IMFire3605]

According to steamengine's Ohm's Law calculator

Resistance = 0.43ohms
Wattage @ 58.8watts
Voltage required= 5.03v
Current = 11.69amps

All lines up

 

[AJ Steele]

Stick with 20 amp batteries in your mod and you should be cool n the gang. As was mentioned above, the protection circutry should prevent you from firing a coil unsuited to your batteries.