New rda problems

[Zach hayes]

I just bought a atty cubed because my plume veils post holes were too small for the coil builds I have been building, I can't seem to get it right every time I build a new coil(3 strand parallel 26 g at around .5 ohms) my istick 50 shuts off which I'm pretty sure is the short circuit protection. I didn't have these problems with my plume veil or mutation x v4. Any suggestions

Sent from my D6616 using Tapatalk

 

[Katmar]

Bump for an answer. Good luck to you....

 

[Zach hayes]

Figured it out the screw on the bottom of the rda wasn't getting a good connection to the mod

Sent from my D6616 using Tapatalk

 

[Zach hayes]

It started back doing it again can't find anything online either

 

[stalkster]

If the build is clean, it;s most likely the 510/middle post. Here's some things to check.
Make sure there's not a small piece of wire in the juice well touching the center post to juice well bottom. Small extra wire cuttings can wield itself to the post/deck.
Make sure your build is not touching the sides inside the rda barrel.
Undo the bottom screw(510) take the post out inspect it make sure the peak or w/e type of insulator there using is not messed up. Also check the bottom insulator.