New to Sub Ohm Vaping, Need Help!

Status
Not open for further replies.

HanaGirl

Full Member
Aug 7, 2014
21
11
Maui
I just got an IPV Mini and an Aspire Peakomizer 2.0 tank with an Aspire Atlantis .5 ohms coil.

I like the setup and the vapor output but I can't taste anything.
When I put my Anyvape Davide on the IPV Mini (with a 2.0 ohms BVC) I get good vapor and flavor at 10W.

I understand that YMMV, but can anyone recommend what I should set the Mini to when I have to sub ohms tank on it? I understand that juice is a factor.
I'm using an Efest 18650 purple battery in the Mini.

I have an iTaste 3.0 vv/vw battery and I used to set that up to 11W. I grabbed the IPV because I want more vapor and flavor and less nicotine.

I'm sorry if this is such a stupid question. I've always wanted to do sub ohms vaping but I didn't want to have to make my own coils and drip vape. The Peakomizer 2.0 tank seemed like the best of both worlds because I can just buy new coils, and I can use regular BVC/BDC in it as well.
 

Ryedan

ECF Guru
ECF Veteran
Verified Member
Mar 31, 2012
12,869
19,652
Ontario, Canada
HanaGirl, I don't have any of that hardware, but I feel can make a couple of comments that might help a bit.

First, I believe the Aspire Peakomizer 2.0 is this tank, correct me if I got this wrong. If it is, it uses Aspire Nautilus heads (coils), not the Atlantis heads you mention.

Now, you say 'I like the setup and the vapor output but I can't taste anything', so I imagine you're getting something from it. The 0.5 ohm Aspire Atlantis heads are I believe rated for up to 30 watts and will probably not do much below around 20 watts. If you're running below that feel free to turn them up and see what happens. You will taste it if you get a burnt vape and if that happens turn the power back down or stop using it.

Best of luck with it and I hope this heals a bit.
 
Status
Not open for further replies.

Users who are viewing this thread