New Z-Atty-Pro. Have questions.

[Beretta]

I just received a Z-Atty-Pro, and the ohms on the built in coil/mesh wick measure 1.8. However, i'm running it at 4.0v. Is this ok? Zen even pushed it this high during his video getting all the coils to light up evenly. What volts should I be running it at?

 

[donnah]

Mine has a stock coil metering 1.8. I'm using mine at 3.9v (I think, I'd have to get out of my recliner to make sure)

 

[varivapr]

I just received a Z-Atty-Pro, and the ohms on the built in coil/mesh wick measure 1.8. However, i'm running it at 4.0v. Is this ok? Zen even pushed it this high during his video getting all the coils to light up evenly. What volts should I be running it at?

Your setup should be fine as long as you don't have any hot spots and it is wicking well. You are running 8.89w. I am currently running a 2.2ohm coil at 5v which is 11.36w with great results. As long as it tastes good and produces alot of vaper run it.

 

[Rule62]

I just received a Z-Atty-Pro, and the ohms on the built in coil/mesh wick measure 1.8. However, i'm running it at 4.0v. Is this ok? Zen even pushed it this high during his video getting all the coils to light up evenly. What volts should I be running it at?

You're in the ballpark. I was just vaping one of mine last night. Factory coil 2.0Ω vaped at 4.2 volts.

 

[pandy_88]

You're in the ballpark. I was just vaping one of mine last night. Factory coil 2.0Ω vaped at 4.2 volts.

im just got mine used for a steal but i had to wrap the metal string thing myself. it came out to 2.6ohm and if i go past 3.7v, it taste burnt. im using the 400x400 wick

 

[varivapr]

sounds like you have a hot spot. You should be able to go well past 3.7v without any burnt taste. Do some searching on how to get rid of a coil hot spot. It has been covered many times