New Z-Atty-Pro. Have questions!

[Beretta]

I posed this question in another forum for RBAs, and received only one answer back, which wasn't really an answer. So i'm posting it here among Provari owners that have a Z-Atty-Pro

I just received a Z-Atty-Pro, and the ohms on the built in coil/mesh wick measure 1.8. However, i'm running it at 4.0v. Is this ok? Zen even pushed it this high during his video getting all the coils to light up evenly. What volts should I be running it at?

When I rebuild the wick/coil, how can I increase the ohms to 2.5 or 3.0?

 

[sachavaca]

more coils, why dont you ask in provari zap forum?

 

[Beretta]

more coils, why dont you ask in provari zap forum?

Can't seem to find that forum.

 

[wonderland]

I would run your volts to taste. Start low and work your way up until it tastes right for you. 4v on a 1.8 coil is close to 9 watts. For higher resistance, wrap an extra coil or two.

 

[Beretta]

Wonderland,
Thanks for the information!

 

[ninfreak]

gennies run better at low ohm(i do not believe in sub ohm coils....they are more dangerous then the people think)....i have been running my zap at 4-4.2 at 1.8 since june

 

[sachavaca]

try the search ecf space near top of page, it helps me a lot to locate threads